Soudal Soudafix P300-SF Chemical Anchor Set Resin 410ml 157705

Soudal Soudafix P300-SF Chemical Anchor Set Styrene Free Low Odour Resin 410ml

MPN 157705

Barcode 5411183179462

Soudal Soudafix P300-SF used with Soudal Soudafix Chemical Anchor Gun 410ml 103265

Soudafix P300-SF is a polyester resin based chemical anchor that's ideal for anchoring of threaded rods and chemical anchors in solid uncracked concrete.

Styrene free, low odour suitable for internal and external use.

M8 to M16 for heavy loads and masonry 18 brick types anchoring.

Soudafix P300 is a 2 part SF styrene free rapid curing chemical resin anchoring system housed in a 410ml cartridge.

Designed for fixing of railings, satellite dishes, signs, brackets and other fixtures which carry heavy loads fixing down machinery etc.

The unique easy dispense technology of Soudafix Anchor Fix has the twin bag system within the cartridge enables the product to be mixed at the nozzle.

Not suitable for cracked concrete use VE400-SF 410ml or VE400-SF 280ml

Not suitable for rebar installation use VE400-SF 410ml or VE400-SF 280ml

Benefits

• Easy mix twin bag system
• 410ml needs to be applied with the soudal Soudafix Chemical Anchor Gun
• Securing of heavy loads in solid and hollow building materials
  
• Rapid curing system
• Super strong
• High chemical resistance
  
• High water resistance
• Pressure free anchoring even close to edges
  

Areas For Use

• Fixing wall ties
• Bolts and screws into a wide range of building substrates
• Securing machinery into floors
• Fixing studs and fixings
• Threaded bar and chemical anchor fixings
• Can also be used as a repair mortar
  

How to use P300-SF

Solid

1. Drill hole at recommended depth
2. Clean the hole with a air pump then with a brush and again with air thoroughly.
3. Screw static mixer onto cartridge and dispense the first 10cm of the product to waste until an even colour dark grey is achieved with no light streaks.
4. Dispense the chemical anchor into the hole from the bottom with the long nozzle working upwards, there needs to be enough product in the hole that the chemical anchor spills over when the rod or anchor is pushed into the mix using a slight backwards and forwards screwing motion, this ensures that no water will sit in the hole and damaging the fixing over time.

Hollow Brick or block

1. Drill hole at recommended depth
2. Clean the hole with a air pump then with a brush and again with air thoroughly.
3. Screw static mixer onto cartridge and dispense the first 10cm of the product to waste until an even colour dark grey is achieved with no light streaks.
4. Insert the sleeve dispense the chemical anchor insert and fill it bottom up so that the resin is pressed through the tiny holes of the sleeve with the long nozzle working upwards, there needs to be enough product in the hole that the chemical anchor spills over when the rod or anchor is pushed into the mix using a slight backwards and forwards screwing motion, this ensures that no water will sit in the hole and damaging the fixing over time.

Don’t move the anchor during curing

Once fully cured install component, applying the right torque

Installation parameters can be found int the technical data sheet

Refer to technical data sheet for instructions prior to commencing work.

Soudal Soudafix Chemical Anchor Demonstration Video Stronger Than The Concrete Itself

Soudal Anchorfix Page

Take a look at the full range of Chemical Anchor Fixings to go along with your Adhesive