Sika Anchorfix 1 Chemical Anchor Resin Styrene Free 300ml SKANCH13

Sika Anchorfix-1 Chemical Anchor Resin Styrene Free

MPN SKANCH13

Sika Code 461476

Barcode 5055492700742

Sika Anchor Fix 1 is a rapid curing two part chemical anchoring cartridge system that's Solvent and styrene free based two part polyester anchoring adhesive resin.

Applied in one single action to produce a cost effective, tough, chemical resistant fixing.

Sika Anchorfix 1 is ideal for close to edge applications as no stress is placed on the surrounding substrate unlike expansive wall plug fixings.

Versatile in use anchorfix-1 is suitable for fixing wall ties, starter bars, studs, bolts, rebar or large screws

Use in brickwork, concrete, masonry, stone etc.

Can be used in a standard 310ml or 400ml strong gun such as the Powerpro Sealant Gun or Cox Heavy Duty Sealant Gun.

Sika Chemical Anchor Demonstration Video

Product Application

Surface Preparation

Drill hole to the correct diameter and depth

For optimum results the hole must be coarse sided.

If the holes are produced by diamond drilling the surfaces should be thoroughly roughened.

Remove all dust and debris from the hole using a hand or air pump.

Bars or Fixings should be clean and free from oil or grease, all flaking rust should be removed.

Threaded rod or studs should be chisel ended to prevent them being unscrewed from the cured resin.

Anchorfix-1 Application:

Attach the mixing nozzle to the cartridge

Place the Anchorfix 1 cartridge into a 300ml or 400ml standard good Quality sealant Gun.

Activate the hand trigger a few times until material passes through the mixing nozzle until an even colour is obtained

Do not be tempted to use material thats not a uniform colour.

Insert the nozzle into the base of the hole activate the trigger with drawing the nozzle slowly as the hole fills

Insert the fixing slowly with a rotating action to the desired depth.

Excess Material should be cleaned off being careful not to get in threads

Prior to any application, the suitability of the Sika AnchorFix Adhesive for the substrate in terms of the desired bond strength,

and for the prevention of surface staining or discoloration, must be confirmed by testing in a sample area.

This is due to the wide variation of possible substrates, particularly in terms of strength, composition and porosity:

Sika SKANCH13 Official Information:

Sika Anchorfix 1 Technical Data Sheet

Sika Anchorfix 1 Safety Data Sheet

Manufacturer product Page