Bond it Brick and Patio Masonry Cleaner 2.5 Litre BDH080

Bond it Brick and Patio Masonry Cleaner 2.5 Litre

MPN: BDH080

Barcode: 5060021361271

Bond It 2.5 Litre Brick and Patio cleaner is a powerful acid based cleaner used for cleaning masonry surfaces such as brick block work patio slabs natural stone and building facades.

Will remove unsightly stains caused by numerous every day occurrences, as well as builders splatter. grime, oil, grease and other difficult-to-remove stains, from brickwork, patios, garages, paving, concrete floors and warehouses, used to remove mortar stains from brickwork Suitable for cleaning unsightly stains, algae, some paints, oils, limescale efflorescence salts from paths patios and driveways.

Bond It 2.5 Litre Brick and Patio cleaner Uses:

For removing cement and mortar splashes, light oil stains and grease from brickwork, paving, tiles, earthenware and concrete.

Bond It brick and patio cleaner should not interfere with the various types of concrete and stone (except limestone and marble) commonly encountered in the general building area.

Efflorescence can also be removed by using this product diluted

Benefits and Areas of Use:

• Small 2.5 Litre Container
• Acid based - powerful cleaning action.
  
• Approximately 15 to 30 meters square per 5 Litres depending on porosity and type of surface,
  
• Water clean up.
• Economical in use.
• Dissolves mortar and cement stains and ingrained dirt also removes algae and limescale.
  
• Cleans masonry surfaces brick block patio natural stone and building facades.
  
• Cleans stains from brickwork, natural stone, concrete earthenware etc (except limestone and marble)
• Cleans stains from patios.
• Cleans garage and factory floors.

How to Use Brick and Patio Cleaner:

• Gloves, overalls, boots and goggles should be worn at all times during application.
• Protect metal surfaces and paint-work before application with polythene sheets and tape.
• Remove excess dirt, mortar, etc. with a stiff yard brush.
• If cleaning down brickwork saturate area with water to prevent damage to mortar.
• Before commencing a full clean down, test on an inconspicuous area with diluted 2:1, water to brick and patio cleaner.
• For normal use dilute between 2 and 4 parts water to 1 part cleaner.
• Apply using a low pressure hose or by brush and allow to stand for 10 to 15 minutes ensuring the area does not dry out and is scrubbed occasionally with a stiff yard brush.
• Rinse thoroughly with large amounts of water, do not add water to neat cleaner, always add the cleaner to the water.
• If stains persist, repeat the process and or use the cleaner undiluted taking care to test the neat cleaner first on an inconspicuous area.
• For removing efflorescence use a 4 to 1 dilution water to cleaner.
• Always use a plastic container for diluting this product such as a paint kettle

Product Limitations:

Do not use Bond It brick and patio cleaner on limestone or marble as the chemicals will attack the surface.

This product can also have an adverse effect on coloured concrete, test an inconspicuous area before use.

For removing mould, lichen or mildew use Bond It Patio Blaster.

If used internally, extreme care must be taken and thorough ventilation provided as fumes can cause damage to sensitive surfaces.