Bond It High Gloss Block Paving Sealer 5 Litre BDHGBS5

Bond It High Gloss Block Paving Sealer 5 Litre

MPN BDHGBS5

Barcode 5056437401366

Bond-it High Gloss block paving sealer is a block paving seal and joint stabiliser based on a clear solvent based liquid formular.

Can be applied by spray, brush or roller, a application roller kit STD49713 is available.

A ready-to-use colourless, solvent-based liquid for sealing, enhancing and protecting paving, blocks and patios.

Bond it block sealer is designed to form a durable seal over block paving and other mineral paving Slabs.

Penetrates deeply into blocks and sand then cures by solvent evaporation, Give a long lasting seal which is resistant to sunlight, water, oil, petrol etc.

Bond It High Gloss Block Sealer Benefits

• Gloss finish for enriched colour.
  
• Long lasting and weather resistant.
• Helps facilitate easier cleaning.
• Contains a powerful fungicide to help prevent the growth of mould, fungus or weeds.
• Protects against staining of oil.
  
• Block paved drives and pathways.
• Cement based flagstones etc
• Resistant to chipping and peeling.
• Hard wearing and durable.
• Unaffected by UV, water or ice.
• Enhances colour of weathered and new paving.
• Resists weed and grass growth between joints.
  

Approximate Coverage:

• 1 litre is sufficient for one coat of approximately 2 to 3 meters square depending on porosity.
  
• 2 coats recommended.
• 2nd coat after approximately 4 to 12 hours.

Drying Times 

• Leave to cure for 24 hours before trafficking
• Light foot traffic when touch dry usually 4 hours but can be up to 12 hours
  

Preparation:

• Remove all loose material by brush and or vacuum.
• Ensure joints are filled with compacted kiln dried sand such as Setting Sand Narrow Joint Filler.
• For existing areas, remove all oil grease and diesel stains.
• Remove weeds, algae etc with a product like Patio Wizard.
• Ensure all areas are completely dry before applying Bond it High Gloss Block Paving Sealer.
• Product should also not be applied at temperatures below 5 degrees C or above 30 degrees C.
  
• If any other previous stabiliser or sealer has been used this must be removed before application

Always read the Technical Datasheet Prior to application

Application Kits Available 9 inch Single Arm Application Kit or 12 inch Double Arm Application Kit

(Please note that tins may get dented in transit and this is not a reason for return please do not purchase tined products if this is an issue for yourself.)