Bond It Drive Alive Clear Coat Block Paving Sealer 4 Litre BDCCBS4

Bond It Drive Alive Clear Coat Block Paving Sealer BDCCBS4

Size: 4 Litre

MPN: BDCCBS4

Barcode: 5060021368300

Product Overview:

Bond It Clear Coat High Build Block Paving Sealer an advanced hybrid technology sealer for use only on interlocking block paving on driveways paths and patios, the sealer is ready to use simply stir and apply to a cleaned surface, it will enhance the present colour and extend the lifespan of the treated blocks, Bond it clear coat is solvent‐free and has a low odour, Bond-It advanced drive alive clear sealer Improves water and UV resistance, it also protects the block paving from water penetration, staining including dirt and grime build-up.

Bond it Drive Alive Clear Coat Benefits:

• Protects from water penetration staining and dirt grime build‐up.
  
• Advanced Hybrid technology.
• Ready to use.
• Excellent abrasion and chemical resistance.
• Contains fungicide which inhibits organic growth.
• Solvent‐free and low odour.
• Facilitates easy cleaning.
• Improves water and UV resistance.
• Suitable for heavily trafficked areas.

Full Application Kits Available:

9 inch Single Arm Application Kit

12 inch Double Arm Application Kit

Bond It Clear Coat Can Be Used in The Following Areas:

• Seals and Protects,
• Block paving,
• Paths,
• Patios.
• Driveway's.

How to Prepare ready For Application Of The Sealer:

• Remove organic growth lichens etc. that may be present.
• For best results pre treat the areas with Bond It PATIO BLASTER refer to data sheet.
• Wash all debris away and ensure the surface is dry and free from oil, grease, dust and loose material that may hinder adhesion.

Applying The Bond It Drive Alive Sealer:

• Drive alive clear coat is ready to use, and does not require diluting.
• We advise that you test this product on a small inconspicuous area prior to use to check compatibility.
• Stir well before use.
• Ensure that the blocks are completely dry, then apply a single coat using either a brush, roller or squeegee, ensuring no pooling or ponding occurs.
• Allow 3 to 4 hours drying time this may be extended depending on conditions before trafficking the area.
• Application temperature must be between +5 degree C and +30 degree C.
• Colder humid conditions will slow drying times and may cause blooming.

Approximate Coverage:

• One 4 Litre container will cover approximately 15 meter square for a single coat depending on surface porosity.

Important Note:

Always reed the data sheet prior to application for does and don'ts.

It is necessary to seal blocks prior to the application of any pointing or jointing compound.

Some compounds have the capability of staining porous paving materials.

Ensure clear coat has completely cured prior to pointing.

Do not apply clear coat to any uncured wet pointing or to any dry mix cement compound.

If applying to new paviours ensure a sufficient period of weathering as recommended by the paving manufacturer has elapsed in order to avoid efflorescence.

Blocks can be resealed using a single coat of clear coat at 3 to 4 year intervals.

The surface may still be sealed even when the surface tension appears to have reduced

Always apply to a small test area and check a few days later.

Avoid over application ponding and pooling.