Bond It Monster Mitre Bonding Kit Superglue Activator BDMI

Bond It Monster High Strength Mitre Bonding Kit Superglue and Activator

Mitre Super Glue 50g Mitre Activator 200ml

Barcode 5036684020107

MPN BDMI

Bond It mitre bonding kit superglue and activator system

A high viscosity ethyl cyanoacrylate adhesive with gap filling properties coupled with an accelerator that overcomes the adverse effects of acidic surfaces such as oak timber and MDF

Two part super glue system comprising an extremely high viscosity 50g adhesive and 200ml aerosol fast activator.

Used primarily for instant bonding  normally 10 seconds on wooden joints, with numerous other uses.

This Mitre Bonding Kit is a set consisting of a high viscosity cyanoacrylate adhesive super glue and activator which when used together create a rapid bond in seconds achieves high bond strength.

Bond It Bonding Mitre Kit System Benefits

• Ideal for wood mitre joints as well as numerous other jobs.
• Ideal for use on vertical surfaces as it will not drip or slump.
• Visually pleasing compared to other adhesive systems.
  
• Flash setting formulation bonds most surfaces within 10 seconds, cutting down dramatically mitre assembly bonding times when compared to conventional wood adhesives.
• High viscosity adhesive low soak in to give greater bond strength than conventional cyanoacrylates on porous surfaces such as wood
• Gap filling high viscosity adhesive will fill small gaps in mitres etc
• Especially suitable for applications where cure speed needs to be accelerated.
  

uses

Fixing and repairing wooden parts.

Multitude of industrial applications Bonds MDF, wood, chipboard, rubber, leather, plastics, Perspex, UPVC ceramics, aluminium and metals.

Ideal for all cornice and profile mitres, trims, picture frames, MDF, skirting and architrave joints, worktop end strips, PVCu trims and much more.

It is particularly useful for production lines such as electronics assembly and uPVC window trim bonding.

Preparation and Application Directions

• Spray aerosol lightly over one face of the joint and allow to dry.
• Apply adhesive to the other face and bring together immediately and apply gentle pressure.

IMPORTANT NOTES

Can be used on uPVC but over application of the accelerator can result in staining, this stain may not become visible for several hours after application.

Specialist UPVC Activator Available if required

Bonding Times

The speed of cure varies according to the substrate to be bonded, timber and metals will have a longer cure time than plastics and rubbers.

Best results are achieved on close fitting parts with a very thin bond line.

Excessive bond gaps will result in slower cure speeds.

Application temperature for applying Bond it Mitre System should be between +5 degrees C and +25 degrees C.

Always read the data sheet prior to use for limitations.