Blue Spot Tools Ironmongery 102mm Zinc Plated Tower Bolt 78006

Blue Spot Tools Ironmongery 102mm Zinc Plated Tower Bolt

MPN: 78006

Barcode: 5028734780062

Weight: 0.17kg

Overview:

This 102mm carbon steel tower bolt from Blue Spot Tools carries a zinc plated finish to guard against rust and moisture outdoors. It comes with all fittings needed and suits permanent installation on timber gates, fences, and shed doors.

At 102mm, this is one of the most widely fitted sizes for standard domestic garden gates and shed door applications. All fixing hardware is included, so no additional parts are required.

Key Features and Benefits

• Carbon Steel Body: Provides a solid base material for an outdoor sliding bolt.
• Zinc Plated Finish: Guards against rust caused by rain and outdoor moisture exposure.
• 102mm Bolt Length: A widely used size for standard garden gate and shed door installations.
• Fittings Included: All fixing hardware comes in the pack - no extra purchases needed.
• 5 Year Guarantee: Backed by a manufacturer guarantee for added peace of mind.

Specs & Attributes

• Bolt Length: 102mm
• Material: Carbon steel
• Finish: Zinc plated
• Weight: 0.17kg

Typical Applications

• Securing timber garden gates
• Fastening side access gates
• Locking shed or workshop doors
• Fitting to fence gate openings
• Securing outbuilding or summerhouse doors
• General outdoor ironmongery on timber

How to Use

• Choose the Position: Hold the bolt against the gate at a comfortable height. Mark the screw hole positions with a pencil.

• Pre-Drill Pilot Holes: Drill holes slightly narrower than the supplied screws. This prevents the timber from splitting on installation.

• Fix the Bolt Body: Align the bolt with the pilot holes and drive the screws firmly into the timber.

• Mark the Keeper: Extend the bolt fully and mark exactly where the keeper needs to sit on the post or frame.

• Fit and Test: Fix the keeper and check the bolt slides cleanly into it. Adjust the keeper position before final tightening if needed.

Frequently Asked Questions (FAQs)

• What size tower bolt do I need for a standard garden gate?
  102mm (4 inch) is one of the most commonly fitted sizes for domestic garden gates. It suits the timber thicknesses found on most standard gate posts and provides a solid bolt engagement with the keeper.

• Can you paint over a zinc plated tower bolt?
  Yes. Clean the surface first to remove any grease, then apply a suitable metal primer before your topcoat. This can provide additional protection on top of the existing zinc coating.

• How do I stop my gate bolt from rattling?
  Rattling usually means the keeper is slightly too wide for the bolt barrel. Try adjusting the keeper position until the bolt sits snugly, or fit a small rubber pad behind the keeper to reduce the play.

• Are tower bolts suitable for use on interior doors?
  Yes - tower bolts work on interior doors, gates, and cabinets. For indoor use, a zinc plated finish is more than adequate since there is no weather exposure to deal with.

• What is the difference between a tower bolt and a padlock hasp?
  A tower bolt is a sliding latch with no lock - it holds a gate closed but cannot be locked. A padlock hasp is a hinged plate designed to take a padlock. For areas needing a physical lock, a hasp and padlock combination is the appropriate choice.

Summary

The Blue Spot Tools 102mm zinc plated tower bolt suits standard garden gate and shed door installations on timber. Carbon steel construction with a zinc plated finish, all fixings included, and a 5 year manufacturer guarantee.