Bond It Exterior Render Pregrit External 10L Bonding Agent Coating BDEPG10

Bond It Render Pregrit External Rendering Bonding Agent Paint Coating 10L

Pack Size 10 Litre

MPN BDEPG10

Barcode 5060021361073

Bond-It Exterior Render Pregrit External bonding agent, a one part pre grit gripcoat paint coating.

A paint on ready-to-use Internal external render bonding agent with added aggregate that provides a key prior to rendering, used as an effective bonding agent for render to concrete, brickwork and blockwork, and as a bonding agent to improve adhesion to smooth surfaces, pre grit can be applied by brush or roller.

Bonding Agent for block brick non similar surface smooth surfaces etc

Contains sand aggregate to provide plaster render key

Ready to use, one coat application

Perfect for use on smooth substrates

Pigmented light green to identify treated areas

Waterproof bonding agent for exterior walls.

For use on concrete, brickwork, light blockwork.

Single one coat application that is then rendered once cured.

Reduces suction on porous surfaces and improves adhesion.

Pre Grit Uses

Render PREGRIT should be used as a primer and bonding aid prior to rendering on surfaces such as concrete, brick and difficult, low or non-porous substrates.

For internal and external use 

Application

Thoroughly stir before use and ensure application temperature is above +5 degree C and that the surface to be treated is free from dust, release agents and any contaminants that may hinder adhesion.

Any contamination must be removed prior to application, including any flaking material ensuring the background is sound and will support the weight of the render.

Do not dilute render pre grit and bond-it recommend a patch test be carried out on a small inconspicuous area to test compatibility prior to full application.

Simply apply 1 coat using a brush or roller ensuring an even coat and allow to dry 6 hours minimum.

This product is coloured light green to identify treated areas.

Protect adjacent surfaces from splashes and remove any EXTERIOR PREGRIT before drying using warm soapy water as later it will not come off.

Product Note

Cold or humid conditions will increase drying times.

Do not use at temperatures below +5 degree C.

Cold or humid conditions will increase drying times.

Product Limitations

Do not use on areas subject to continual damp this is not a DPM.

Do not dilute.

Do not exceed a maximum thickness of 25mm for complete render system.

Remove any contamination of product to surrounding surfaces before drying.

Coverage

Depending upon surface porosity 10 litre of EXTERIOR PREGRIT will cover approximately 30 meters square 

Also Available Internal Plaster Pregrit