Bond It De Bond Mate Silicone Sealant Remover 125ml Dissolver Eater Tube
Barcode 5060021369406
MPN TubeDBON1125
Bond It Silicone Sealant Remover high viscosity gel an easy to use and revolutionary product that's designed to remove all silicone based sealants it works on both cured and uncured sealant.
bond it silicone sealant remover is a non drip gel formula for the complete removal of cured silicone sealant, particularly when silicone has been accidentally smeared over glass, ceramics or counter tops. Removes all types of silicone and sealant by breaking up and digesting the material, leaving smooth surfaces clean and ready for re-sealing, perfect for use in bathrooms, kitchens, plastics to plastics on windows and cladding.
Works on cured and uncured Sealant.
Acts by digesting silicone making them easily water or solvent rinsible.
Readily digests silicone sealants.
Ready for use gel that stays where its put.
Use vertically as well as horizontally with no slump.
Water clean up.
Low hazard formulation
Areas For Use
Should be used to remove old silicone sealant during renovations.
It is suitable for use on brick, concrete, PVCu, melamine laminates, acrylic, uncoated aluminium and its alloys, copper and its alloys, iron and steels, glass and ceramics, epoxy composites without adverse effect.
Has little impact on rubber and non silicone elastomers or most painted surfaces.
It is prudent to always test a small area before use.
For use internally and externally
How To Use
All surfaces must be clean dry and dust free
Cut
away as much as possible of the silicone sealant using a sharp knife protecting surrounding areas.
Best results will be obtained by
keeping an even pressure on the trigger and keeping the gun at a
constant angle to the surface being sealed.
Spread the bead over the entire area which requires sealant removal use masking tape to protect surrounding areas if necessary.
A coating of at least twice the thickness of the underlying silicone should be applied.
Allow to stand for at least 2 hours this may vary depending on the characteristics of the silicone and sealant substrate but are typically between 2 to 12 hours.
Wipe clean with a paper tissue, wipes or dry cloth and ensure all traces of solvent are removed.
Repeat the process if necessary.
Keep some water handy to deactivate and wash away any runs.
Surfaces should be degreased with a solvent, such as methylated spirit, or wipes before applying fresh sealant.
The product specifically removes silicone It may only have a softening effect on acrylics, GP mastics and other sealant.
Interest free