Everbuild Roll & Stroll 25m Hard Surface Floor Protector ROLLHARD20

Roll & Stroll Hard Surface and Floor Protector 25 meters

Barcode 5029347606077

MPN ROLLHARD20

Sika Code 462110

Everbuild Roll and Stroll 25m Hard Surface Protector is the ultimate self adhesive hard surface protector, Ideal for protecting against mess, dirt, staining, spillages and soiling that occurs

during painting and Building work.

Protects most hard surfaces including timber, ceramic tiles, laminate, vinyl, metal and stone.

Roll & Stroll can also be used to protect worktops, window cills, doors, kitchen units and glass.

Totally waterproof, protects against expensive to clean paint spillages on hard surfaces.

Due to the adhesive face being reverse wound, Roll and Stroll hard surface is easily unwinds with minimum effort

Will not creep and wrinkle after application.

Easily removed, will not leave a sticky residue.

Can be left for up to 4 weeks.

Adheres to most common hard surfaces.

Safer than dust sheets as there are no trip hazards associated with normal cotton dust sheets.

Rollhard20 Limitations:

This product is for application to hard surfaces only

On carpets Use Roll and Stroll Carpet Protector.

Remove after a maximum of 4 weeks to prevent a sticky residue being left.

In heavily trafficked areas or where air temperature exceeds 220 deg C remove Roll and Stroll after 1 week maximum.

Do not use under floor heating whilst product is in situ.

How To Use:

Ensure surfaces to which ROLL & STROLL isto be applied are clean sound, dust free and dry. Remove outer packaging from roll. Place roll on the floor facing the direction it is to be applied and unwind approx 12 inches 300mm ofmaterial. Ensure the roll is stuck by smoothing out by either hand or foot. Simply push roll forward using hands or feet ensuring roll goes in a straight line. Smooth out with hands or feet as it unwinds. A very effective way of laying Roll and Stroll is to push the roll along with a soft broom brush using the brush to smooth out and remove air bubbles as it unwinds. For application to worktops glass etc roll and smooth out by hand until required length is reached. Carefully cut ROLL AND STROLL with a sharp knife or scissors, take care not to damage or scratch the covered surface.

Everbuild ROLLHARD20 Official Information:

Everbuild Hard Surface Protector Safety Data Sheet

Manufacturer Everbuild Hard Surface Protector Product Page

All Roll and Stoll Protective Surface Film