Aquaseal Wet Room Tanking Kit 7.5m Large Full Kit AQWRSKIT

Everbuild Aquaseal Tanking System Large 7.5 Meter Kit designed to go behind the tiles to waterproof shower and wet room areas from devastating leaks.

Sika Code 487861

MPN AQWRSKIT

Barcode 5029347611149

Large 7.5meter Tanking Kit the Aquaseal Wet Room System is designed to provide a permanently flexible watertight membrane prior to tiling

Use in areas such as showers, wet rooms, wet zones, bathrooms, tiled areas subject to water exposure, balconies, partially covered external areas.

"Based on tried and tested wet room tanking principles used in areas such as Scandinavia & Germany where wet rooms have been common for many years"

Kit consists of a primer, tanking tape, tanking membrane drain mat.

Benefits and Areas for Use

• For showers, wet rooms and wet zones in bathrooms
• Use on all board joints, corners & pipe entries.
• Waterproofing prior to tiling.
• For use on plasterboard, MDF, concrete, wet room boards, plywood etc.
• ply lined wooden floors

Limitations

Do not use on timber treated with spirit or stearate based coatings

Do not use in areas subject to high temperatures

It is the users responsibility to determine suitability for use.

If in doubt contact Everbuild Technical Services for advice.

Surface Preparation

All surfaces must be clean sound and dust free.

This Kit The Large Size Kit:

Aquaseal Wet Room System is a Waterproof Tanking Kit that contains all you need to waterproof 7.5 square metres

Products in each kit

STEP 1 WATERPROOF TANKING PRIMER 1 Litre

A ready to use primer, applied by brush to all porous and semi porous surfaces in the areas that are to be waterproofed.

It is quick drying and can be over coated after 1 hour same size in both kits

STEP 2 WATERPROOF TANKING TAPE 10 Meters which is usually sufficient to waterproof the corners in a 7.5 square metre application.

Self adhesive joint & corner sealing butyl backed fleece tape that should be applied to all corner joints, board joints and pipe penetrations to provide a watertight seal that accommodates cross directional movement.

The tape can be over coated with Aquaseal Waterproof Tanking Membrane immediately after application.

On internal corners ensure the tape overlaps on both sides to avoid a weak spot in the centre of the internal corner.

STEP 3 WATERPROOF DRAIN MAT 1 x 300mm x 300mm

Self adhesive butyl backed fleece capable of coping with board movement around the drain outlet, which is the area most susceptible to water leaks.

STEP 4 TANKING MEMBRANE 5 Litre

A ready to use, liquid waterproofing compound which is applied in a 2 coat system by brush to provide a permanently flexible watertight membrane.

Non-hazardous and solvent free.

It is quick drying and tiling can commence after 24 hours.

Everbuild Large AQWRSKIT Datasheets

Aquaseal Tanking System Technical Data Sheet

Aquaseal Tanking Tape Safety Data Sheet

Aquaseal Tanking Membrane Safety Data Sheet

Aquaseal Tanking Primer Safety Data Sheet

Manufacture Product Page

All Wet Room Bathroom Kits