Everbuild Silicone Sealant Eater Remover Gel 100ml Tube
Barcode 5029347115005
MPN SILEAT
Everbuild Silicone Sealant Eater Remover Gel an easy to use and revolutionary product thats designed to remove all silicone based sealants
Works on cured and uncured Sealant.
Acts by digesting silicone polymers making them easily water or solvent rinsable.
Readily digests silicone
Ready for use gel
Use vertically as well as horizontally with no slump.
Water clean up.
Low hazard formulation
Areas For Use
May be used on aluminum, alloys, copper, iron, steels, glass, ceramics, epoxy composites, most plastics.
Has little effect on most rubber and other elastomers.
Has little effect on most painted surfaces.
How To Use
All surfaces must be clean dry and dust free
Cut
away as much as possible of the silicone sealant using a sharp knife protecting surrounding areas.
Best results will be obtained by
keeping an even pressure on the trigger and keeping the gun at a
constant angle to the surface being sealed.
Spread the bead over the entire area which requires sealant removal use masking tape to protect surrounding areas if necessary.
A coating of at least twice the thickness of the underlying silicone should be applied.
The
dwell time required may be varied between 2 hours to 4 hours depending
primarily on the characteristics of the underlying silicone and the
substrate from which it is to be debonded.
Repeat application if necessary.
Wash off with water after 4 hours maximum.
The product specifically removes silicone
It may only have a softening effect on acrylics, GP mastics and butyl sealant.