Cromar Flat Roof Cold Gritting Chipping Adhesive 25 Litre ACG-601

Best Price Trade Deal 25 Litre Large Tub

Cromar Flat Roof Cold Gritting Chipping Adhesive 25 Litre

MPN ACG-601

Barcode 5036684002806

Large 25 Litre Drum the most cost effective way of purchasing this cold gritting solution used to bond grit and chippings to roofing felt.

Cold applied, black oxidised bitumen based adhesive roof coating.

A solvent based cold applied bituminous adhesive roof coating for bonding chippings to flat or low pitched roofs up-to a 10 degree slope.

The adhesive is supplied ready to use and must not be diluted or heated, it is designed to bond a wide variety of aggregates to built-up felt and mastic asphalt roof surfaces.

Cromar cold gritting adhesive will then provide a final solar reflective heat protection element a weather-proof and damage resistant surface.

Chippings compatible with Cromar Cold Gritting Adhesive include

• Limestone
  
• Granite
• White calcined spar
• Flint
• Gravel
  
• Slate mineral chippings

Benefits and Use

• Seals the roof.
• Bonding Gritting Chippings to final layer of felt.
• High bond strength.
• Cold Applied no flames.
• Ready to use.

Cromar Flat Roof Gritting Adhesive Approximate Coverage

• Chipping sized 3mm to 9mm – 1.8 meters square per litre
• Chipping sized 12mm – 1.3 meters Square per litre

Method of application

• Cold Gritting Adhesive should be applied by stiff brush, mop or squeegee.
• To avoid thickening in cold weather, store Cold Gritting Adhesive in a warm room overnight prior to use
  

Instructions

1. All surfaces must be free from oil, dirt, dust and loose debris.
2. The surface should be preferably dry although the product may be applied to a damp but not wet or waterlogged surface.
3. The compound should be spread evenly direct from the container in convenient areas of 20 meter square at a time.
4. Do not allow pooling of the solution or the covering to be too thin.
5. The chippings should be applied immediately into the wet film.
6. Care should be taken not to over-chip and to ensure that the chippings cover the film shoulder to shoulder.
7. Proceed to the next 20 meter square area.
8. Leave the completed areas for at least 72 hours and then lightly brush off any excess chippings.

Do not leave any blank film exposed.

Always read the technical data sheet prior to using Cromar Cold Gritting Adhesive

Take a look at the Full Range of Roofing and Guttering Products.

(Please note that tins may get dented in transit and this is not a reason for return please do not purchase tined products if this is an issue for yourself.)