Everbuild Silicone Sealant Eater Remover Gel 100ml Box of 12

Trade Option : Box of 12

Everbuild Silicone Sealant Eater Remover Gel 100ml Tube

Option Code: SILEAT-12

Barcode: 5029347115005

Trade Discounted box of 12 Everbuild Silicone Sealant Eater Remover Gel is a revolutionary product thats been designed to remove all silicone based sealants, works on cured and uncured Sealant.

Acts by digesting silicone polymers making them easily water or solvent rinsable.

How To Use:

All surfaces must be clean dry and dust free, cut away as much as possible of the silicone sealant using a sharp knife, protect surrounding areas.

Best results will be obtained by keeping an even pressure on the trigger and keeping the gun at a constant angle to the surface being sealed.

Spread the bead over the entire area which requires sealant removal use masking tape to protect surrounding areas if necessary.

A coating of at least twice the thickness of the underlying silicone should be applied.

The dwell time required may be varied between 2 hours to 4 hours depending primarily on the characteristics of the underlying silicone and the substrate from which it is to be debonded.

Repeat application if necessary.

Wash off with water after 4 hours maximum.

The product specifically removes silicone

It may only have a softening effect on acrylics, GP mastics and butyl sealant.

Readily digests silicone

Ready for use gel

Use vertically as well as horizontally with no slump.

Water clean up.

Low hazard formulation

Areas For Use:

May be used on aluminum, alloys, copper, iron, steels, glass, ceramics, epoxy composites, most plastics.

Has little effect on most rubber and other elastomers.

Has little effect on most painted surfaces.

Data Sheets:

Everbuild SILEAT Silicone Eater Technical Data Sheet

Everbuild SILEAT Silicone Eater Safety Data Sheet

Manufacturer SILEAT Silicone Sealant Eater Product Page

Take a look at the full range of sealant tools from CornerTape.