Everbuild Black Jack Self Adhesive Flashing Tape 10m X 75mm Box Of 8
Everbuild Black Jack Self Adhesive Flashing Tape 10m x 75mm Box 8
Everbuild Flashing Tape 10m x 75mm
Product Option: FLAS075 - Box of 8
75mm Wide Aluminium foil and bitumen rubber self adhesive flashing tape
The adhesive forms a strong waterproof seal by the simply pressing the tape into place by hand or roller.
Areas of Use & Benefits:
Replaces need for expensive lead flashing.
Self-adhesive requires no separate glue.
General repair to existing flashing.
Flashing bituminous felt and similar types of roofs.
Flashing parapet walls.
Sealing roof glazing.
Replacing lost lead flashing.
Repairs to cracks in concrete.
Repairs to lead gutters.
Sealing capping bolts in roof sheets.
Sealing roof ridges.
Flashing between timber brickwork or blockwork cavities.
Flashing of skylights
Preparation & Application:
Surfaces must be dry,
Sound free from oil, grease and dust
Remove all loose material by scraper or wire brush.
Porous surfaces, such as concrete or brick, should be primed using Everbuild flashing tape primer.
Cut to the required length.
Peel beck approximately 5cm of release carrier and place the tape into position.
Continue removing the release carrier whilst firmly placing the tape
Avoid unnecessary creasing.
Ensure intimate contact and ensure no air is trapped.
Using a small seam roller ensure that all edges and overlaps are sealed properly.
Overlaps should be at least 25mm.
Important Product Notes:
Prime porous surfaces with Everbuild flashing primer.
Do not apply to damp surfaces.
In cold weather adhesion may be reduced.
Bring up to temperature or heat bitumen adhesive layer with a hot air gun to improve adhesion & pliability.
Flashing Tape Data Sheets: