Everbuild Black Jack Self Adhesive Flashing Tape 10m X 150mm Box Of 4
Everbuild 10m x 150mm Black Jack Self Adhesive Flashing Tape Box 4
Everbuild 10m x 150mm Flashing Tape Box of 4
Product Option: FLAS150-Box of 4
150mm Wide Strong self adhesive flashing tape Box of 4
Aluminium foil and a bitumen rubber adhesive.
The adhesive forms a strong waterproof seal by the simply pressing the tape into place by hand or roller.
Replaces need for expensive lead flashing.
Self-adhesive requires no separate glue.
Some Areas Flashing Tape Can Be Used:
General repair to existing flashing.
Flashing bituminous felt and similar types of roofs.
Flashing parapet walls.
Sealing roof glazing.
Replacing lost lead flashing.
Repairs to cracks in concrete.
Repairs to lead gutters.
Sealing capping bolts in roof sheets.
Sealing roof ridges.
Flashing between timber brickwork or blockwork cavities.
Flashing of skylights
Awkward areas and tops of existing lead flashing can be pointed using
larger flat areas can be coated with Evercryl Fibre reinforced coating this will bring small holes.
Surfaces must be dry,
Sound free from oil, grease and dust
Remove all loose material by scraper or wire brush.
Porous surfaces, such as concrete or brick, should be primed using
Cut to the required length.
Peel beck approximately 5cm of release carrier and place the tape into position.
Continue removing the release carrier whilst firmly placing the tape
Avoid unnecessary creasing.
Ensure intimate contact and ensure no air is trapped.
Using a small seam roller ensure that all edges and overlaps are sealed properly.
Overlaps should be at least 25mm.
Prime porous surfaces with Everbuild flashing primer.
Do not apply to damp surfaces.
In cold weather adhesion may be reduced.
Bring up to temperature or heat bitumen adhesive layer with a hot air gun to improve adhesion & pliability.